Xingtai Aohua Rubber Seal Products Factory: Car Daily Maintenance (3)
Description：A, cleanAir contains a lot of dust, sand and acid substances, not only easy to be leakage of fuel ad....
A, clean
Air contains a lot of dust, sand and acid substances, not only easy to be leakage of fuel adhesion, under high temperature baking easy to form a hard insulation layer, so that the heat dissipation performance of the parts become poor, and easy to be the body electrostatic absorption and erosion paint surface, make its premature fading.
1. Clean the air filter
Air filter too dirty will steeply block fresh air into the cylinder, resulting in gas concentration, incomplete combustion, power decline, exhaust beyond the limit. Modern air filters generally use paper filter elements. Note: do not wash with water or oil. Tap method and blow method should be used. Dab the end face of the filter element to make the dust fall off. Blow cleaning means that the compressed air filter element is blown outwards, air pressure: force should not exceed 0.3N/Pa
2. Clean the oil filter
Clogged oil filters can impede the flow of lubricating oil, resulting in poor lubrication, increased wear, and even tile burning. For this purpose, clean or replace regularly. It is usually replaced every 8000km if the weather is dry. It should be shortened to 5000km and replaced once.
3, clean the battery
Modern cars generally use maintanance-free battery, first clean the top of the battery, avoid pole between the electrolyte or other impurities caused by short circuit; Secondly, clean the battery terminal block to prevent the joint from producing oxide and resulting in bad contact. Air vent should be unblocked, lest the pressure or temperature in the battery is too high and make the hand burst.
This article by Xingtai Aohua rubber seal products factory finishing
